Turbochef-technologies TurboChef User Manual download pdf (Page 49)

ADJUSTING THE OVEN DOOR

WARNING: Procedure should be done while

oven is hot. As a result, exercise extreme

caution when adjusting the door.

1. Open the oven door and remove the plastic caps.

2. Ensure that the 3 screws on each side of the door

are tight.

3. Remove the control panel, two

” nuts and

wiring from I/O board.

4. Loosen the hex screws and close the door.

5. Tap the center of the door to allow door and

frame to align properly.

6. Tighten screws and reinstall the control panel.

7. Plug in the oven and perform a MW leak test (see

page 31 for instructions).

Critical Adjustment Notes

1. The doors in Figures 27 and 28 are adjusted

incorrectly. Note how the bottom (Figure 27)

and top (Figure 28) of the door can be rotated

away from the Flange.

CORRECTIVE ACTION: Loosen the hex screws

and push the door towards the flange and re-

tighten. The hinge springs will naturally pull the

door to the flange. Tapping the center ensures a

level surface and a proper seal, as opposed to

pushing one end (which could cause the opposite

end to lift away from the flange).

Pull the door open only 0.25” (6 mm) and let go

of the handle. The door must completely snap shut

on its own. If the door sticks and force is needed

to finish closing it, it is out of adjustment.

NOTE: See Figure 26, page 37, Items 43-46 for illus-

tration of hardware.

WARNING: Check for excessive Microwave

Leakage after adjusting the Cook Door. See

page 31 for proper procedure.

PREPARING THE OVEN FOR SWITCH ADJUSTMENT

1. Disconnect the power to the oven and remove

left and right side covers.

2. Ensure oven door assembly is properly adjusted

and all mounting screws are secured (see previous

section on adjusting the oven door).

3. Ensure the left and right hinge assemblies are

properly mounted to the oven flange.

Oven Burn-In Procedure

If the oven is already at its set temperature at the

time of service, skip this procedure.

1. Apply power to oven.

2. Simultaneously press the

BACK and ENTER

keys.

3. Enter 8-6-4-8 (

U-N-I-T), then press ENTER.

4. Press

BURN-IN. The oven will warm up and

idle for 25 minutes.

ADJUSTING THE PRIMARY AND SECONDARY

INTERLOCK SWITCHES - OLD SWITCH SETUP

The old switch assembly is identifiable by the pri-

mary and secondary interlock switches being

located on the left side of the oven. Also, the serial

number of the oven will follow the formatting

below (X = variable digit/letter):

NGC-XXXXX (North America)

NGCXX-XXXXX (International)

To properly adjust the switches, follow the proce-

dure below:

1. Ensure the oven door is adjusted properly. Refer

to the previous section on adjusting the oven

door.

2. Unplug the oven.

THE OVEN DOOR

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 93 94

Comments to this Manuals

No comments

Turbochef-technologies TurboChef User Manual Page 49

Comments to this Manuals

Related products and manuals for Microwaves Turbochef-technologies TurboChef