Turbochef-technologies TurboChef User Manual download pdf (Page 54)

ADJUSTING THE SECONDARY AND MONITOR

INTERLOCK SWITCHES - NEW SWITCH SETUP

1. Disconnect power to the unit.

2. Disconnect the 40-pin connector from the I/O

board to allow maximum clearance.

3. Using the 0.060” (1.524 mm) spacer as a

template (included with item 74), adjust the

secondary switch.

NOTE: This will also adjust the monitor switch.

4. Open and close the door several times to verify

the switch gap.

NOTE

: The absolute maximum gap should not

exceed 0.060” (1.524 mm).

5. Re-connect the 40-Pin connector to the I/O

board and apply power to the unit.

6. Simultaneously press

BACK and ENTER keys.

7. Enter 9-4-2-8, then press

ENTER.

8. Open the oven door and verify P, S, and M

disengage in sequence.

9. Close the oven door and verify the M, S, and P

engage in sequence.

10.Energize the Microwave System and open the

door.

11.Verify the W indicator is backlit, meaning the

oven microwave system turns OFF when the

door is open.

SECONDARY AND MONITOR SAFETY SWITCH PARTS

Figure 33 and 34

77. 102804 Hinge, Right

78. 102012 Switch, Limit, Micro (x2)

79. NGC-1126 Plate, Door Switch

80. 101914 Standoff, #8-32 F/F x 1”, 5/16”

DIA

81. 101915 Standoff, #8-32 M/F x 5/16”,

1/4” DIA (attached to outside

of Item 80.)

82. 102921 Screw, #8-32 x 3/8”

83. 101558 Screw, 4-40 x 1.125”

FIGURE 33: Secondary/Monitor Adjustment and Parts -

New Switch Setup

FIGURE 34: Secondary/Monitor Switch Assembly -

New Switch Setup

THE OVEN DOOR

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 93 94

Comments to this Manuals

No comments

Turbochef-technologies TurboChef User Manual Page 54

Comments to this Manuals

Related products and manuals for Microwaves Turbochef-technologies TurboChef