Turbochef-technologies TurboChef User Manual download pdf (Page 39)

FIGURE 22: Wave Guide Cover/Wave Guide Removal and Replacement

To determine software type,

1. Make sure the oven is in the

COOLING

DOWN

OVEN OFF mode.

2. Simultaneously press the

BACK and ENTER keys.

3. Enter code 9-4-2-8 (

W-H-A-T) and press ENTER.

4. The top line on the screen will display the word

TEST, followed by the software type (for

example,

V2SWY, or TRNADO).

WAVE GUIDE COVER REPLACEMENT

The wave guide covers keep moisture and debris

out of the wave guides. If contamination gets into

the wave guides, the life of the magnetrons may be

shortened. Be careful to not allow debris to enter

the wave guides when replacing the covers.

To remove the wave guide covers, reference Figure

22 and follow the steps below:

1. Locate the fourteen (14) #8 sheet metal screws

securing the broken wave guide cover. If the

screw heads are dirty, it will be necessary to

clean the heads thoroughly.

CAUTION: Do not strip the screw heads.

2. Remove the fourteen (14) #8 screws. The cover

should come loose with gentle pressure.



DO NOT remove the two right and left-most

screws (Item 30). These screws secure the wave

guides to the oven floor. Only remove them if the

wave guide is also being serviced.

3. Remove the old wave guide cover and discard,

unless otherwise specified.

NOTE: It may be necessary to gently pry the

wave guide covers to remove them from the

oven floor as they are sealed with

RTV.

THE MICROWAVE SYSTEM

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 93 94

No comments

Turbochef-technologies TurboChef User Manual Page 39